Step 6.

Then take your funelweb system and fill it with some mix. Then put in some boilies, and then some more mix.

Step 7.

Put the compressor into the tube and press down to form a small sausage.

It is very easy to fill the tube with to much mix, try to keep the sausage to a 4-5 cm long

Step 8.

Then push it out of the end of the tube.
Then pull off some of the PVA mesh off the tube (Fig 1.) and tie 2 overhand knots in it, one on top of the other. (See Fig 2. 3. 4. 5. 6. & 7.)
Then cut the PVA mesh inbetween the 2 knots with a pair of scissors.
(see Fig 8.)

Fig 1.

Fig 5.

Step 9.

Attaching the Bag

There are different ways of attaching the PVA stick to the rig. The easyiest way is to attach it directly to the hook by just hooking it through the mesh a couple of times.

 

The second way is by threading it onto the hooklink itself this is not an easy way and works better if you have a Korda Quick link system hooklength.
Clip the rig off and take a stringer needle right through the sausage. Then pull the hooklength back through the center of the sausage and then clip it on again.
Then tuck the hookpoint into the mix through the mesh and tighten it all up.

Point to note:

If you add oil to the mix use the bag straight away.

The oil can soak into the pva mesh and prevent water from soaking in and melting/dissolving it.